Owner`s manual
Memory full error. Select
a
smaller block
of
text.
See
"Reference
C,
Memory Required
by
the
TEXT Paste Buffer."
ADRS.DO
or
NOTE.DO
not
found.
You do not
have
a
file
named NOTE.DO
or
ADRS.DO
in
the
specific
RAM
bank
you
are using.
#VALUE! error. Your formula
asks MSPLAN
to
make
a
computation
on
strings, rather
than numbers.
(If a
space
precedes
a
number, MSPLAN
regards
its
value
as a
string.
For
example,
" 32" is a
string;
"32"
is
a
number.) Change
all
strings
to numbers.
—
TELCOM
Cannot establish
a
connection.
If
you
do not get
TELCOM's
terminal function-key display
(Prev, Down,
Up,
etc.),
you
have
not established
a
connection
for
one
of
many reasons.
1.
The
connectors:
If
using
the
modem
cable—the
beige cable
goes
to the
wall line,
the
grey
cable goes
to the
phone line,
and
the plug goes
to the
Model
200
PHONE socket.
If
using
the
acoustic
coupler—the
telephone
speaker goes
to the
acoustic
coupler microphone,
the
telephone microphone goes
to the
acoustic coupler speaker,
and
and
the
plug goes
to the
Model
200 PHONE socket.
2.
The
ACP/DIR
setting: If us-
ing
the
modem cable, this switch
must
be set to
DIR;
if
using
the
acoustic coupler,
it
must
be ACP.
3.
The
communication parame-
ters:
Make sure they
are set to
M7E1ENN,
O.
4.
CompuServe's baud rate:
You
must call
one of
CompuServe's
300-baud numbers.
5.
The
sequence
for
establishing
terminal connections: Make sure
you hear CompuServe's
computer tone before pressing
the TERM
key.
CompuServe
is
sending many
unreadable characters. This
is
usually because
you do not
have
your communication parameters
set correctly. With CompuServe,
they should
be
M7E1ENN,
O.
CompuServe
is
sending
occasional unreadable characters.
This
is
probably caused
by a bad
telephone line. Hang
up and try
again.
CompuServe's characters
are
scrolling faster than
you can
read
them. Press
the
Previous
key
(OLD)
to see the
previous screen.
Press
(F1
)
again
to see the
current
key.
The characters
you
type appear
in duplicate. Press
(ED to
change
from
"Half" to
"Full."
References
/ 51