Specifications

Page 29

DRILL DEPTH IS: 2813

To set the depth counter, enter the command followed by the new depth.

>Setdepth 2800[ENTER]

DRILL DEPTH IS: 2800

CGTEMP

This command will allow the user to set the column temperature remotely or through the console. To use just

enter the command with the desired temperature to run the column at. NOTE: Do not generally run the column

over 210 degrees F. There is a thermal fuse set at 240 degrees F. Temperature is in degrees F.

CGTEMP 150[ENTER]

CGSAMPLE

This is also a troubleshooting command. When issuing this command the Bloodhound will automatically

restart a chromatograph cycle no matter where it is in the chromatograph timing. This command is used to

help calibrate and troubleshoot the chromatograph.

CGASMPLE[ENTER]

WRITEETIME

This command is used to individually set the timing of the CG center point (peak), in seconds.

WRITEETIME C1 70

This example would set the peak timing for C1 to 70 seconds.

MUTE

The mute command will allow the remote user to silence or turn off the local alarm tone generator.

To set the mute for a number of minutes, just add the modifier.

MUTE 0[ENTER]

Will turn on the alarm tone if an alarm is present

MUTE 5[ENTER]

Will mute the Bloodhound for 5 minutes

MUTE 1000[ENTER]

Will turn off the Bloodhound alarm.

NOTE: If there is no present alarm, the tone will not be sounding, even if set to 0. Setting MUTE to a number

greater than 1000 has no effect.

Sending a question mark [enter] to the console will return the string Bloodhound and the model number 4.

This allows for the charting software or any other software to check to see if there is a Bloodhound connected

to that port.

?[ENTER]

Bloodhound 4