User's Manual
Periodic Maintenance Checks
System Device
How Often
What to look for
GPS Mobile Unit
Daily
-Check Battery status light
-Review chart for status indicators (see page 8).
Containment Boundary
Monthly and after a
thunderstorm
-Verify the GPS signal is active throughout the
property; see Monthly Containment Boundary
Test below.
Monthly Containment Boundary Test
You should always be aware of your system’s containment boundary. Check for activation in a minimum of
four places throughout the containment system. Always check the signal field from the same four places along
the containment boundary. Take the GPS Mobile Unit off your pet to measure the containment boundary.
Hold the GPS Mobile Unit with the GPS Antenna facing up.
Hold the GPS Mobile Unit about the same height and at the same angle as it will be when the pet is
wearing it.
Walk slowly toward the containment boundary. The GPS Mobile Unit will activate when you reach the
edge of the signal field. DO NOT touch the correction posts at this time!
If the GPS Mobile Unit does not sound a warning tone where the edge of the signal is supposed to be,
immediately call your Invisible Fence
®
Brand Dealer for service. Use a leash (lead) or other means to contain
your pet until all necessary service has been completed.
Troubleshooting
Symptom
Possible Cause
Action
Pet is getting out:
-Battery is dead in the GPS Mobile
Unit
-GPS Mobile Unit is not fit properly on
the pet.
-Power is not supplied to the
transmitter or power is out.
-Pet needs additional training.
-Charge the GPS Mobile Unit
-See page 7 for properly fitting
the collar.
-Make sure transmitter power
supply is plugged in.
-Contact your Invisible Fence
®
Brand Dealer for additional pet
training.
Pet will not enter
the yard.
-Pet needs additional training.
-Contact your Invisible Fence
®
Brand Dealer for additional pet
training.
GPS Mobile Unit
will not respond to
the Containment
Boundary
-Battery is dead in the GPS Mobile
Unit
-Power is not supplied to the
transmitter or power is out.
-Charge the GPS Mobile Unit
-Make sure transmitter power
supply is plugged in.










