User's Manual



NOTICE
When applying the template there should be a minimum of 3” (7.6 cm) between
the bottom and sides of the door and the outer edge of the template to maintain
the structural integrity of the door.
Step 3
Cut Pet Door Opening
3A3B
3A Drill 1/2” holes in the inside corners of template. These will be the pilot holes for the
saw blade. Use a 3/8” drill bit to mark the mounting holes. Make sure that the drill is
level to endure the holes line up on interior and exterior of door. You will need to
enlarge the mounting holes on the interior side to ensure that the mounting post can be
inserted. Remove template from door.
Helpful Tip: Use both hands to hold drill steady and straight at a 90° angle.
3B Beginning in one of the pilot holes, cut along the template lines. You may need to
recut to square the opening. This is necessary for the pet door frame to fi t correctly.
Helpful Tip: Use a proper saw blade according to door material. Ensure that the
blades are sharp and straight. When cutting use both hands to hold the saw slow,
steady and straight at a 90° angle. This will prevent the blade from cutting
unevenly between interior and exterior areas of door.
NOTICE
Make sure there is nothing underneath the door where you will be drilling the
holes or cutting out opening.
Step 4
Install Pet Door
Before putting away the jigsaw, check fit by placing the interior frame (frame with the
control panel) inserting the mounting post into the mounting holes and putting frame
inside cutout. Repeat with the external frame. If frames do not fit inside the opening,
you may need to recut to square the opening before proceeding with installation.
4 Re-hang door and place interior frame on the door by inserting the mounting post in
the mounting holes. Make sure that the interior frame is flush with the door. Place
exterior frame by repeating interior frame steps. Make sure the mounting post on interior
and exterior frame align.
Step 5
Insert Screws