User's Manual



7
Multi-Area Shielding
Your Indoor Micro Shields
®
Transmitter and the Computer Collar
®
unit are preset to operate on Channel A (CH.A).
For homes with two or more pets, this setting is usually sufficient as long as all pets are required to avoid the same
protected areas like keeping all pets away from the trash, off the counter tops off the sofa, etc. In some multi-pet
homes, it may be desired to allow one pet access to an area while denying access to another pet.
• When set to Channel A (CH.A), the Indoor Micro Shields
®
transmitter denies access to pets wearing a
Computer Collar
®
unit programmed to Channel A. (Channel A is the default setting for the Computer
Collar
®
unit.)
• When set to Channel B (CH.B), the Indoor Micro Shields
®
transmitter denies access to pets wearing a
Computer Collar
®
unitprogrammed to Channel B.
• When set to Channel A-B (CH. A and CH.B), the Indoor Micro Shields
®
transmitter denies access to all
pets wearing a Computer Collar
®
unit.
ProgrammingtheComputerCollar®unit
1. Ensure all Computer Collar
®
units are removed from pets and are at
least 3 feet from the Indoor Micro Shields
®
transmitter.
2. Follow procedure above, Changing the Channel Setting on the
Indoor Micro Shields
®
transmitter, to select Channel A or
Channel B to program into the Computer Collar
®
unit. Note: The
Indoor Micro Shields
®
transmitter will not enter into programming
mode if this switch is set to A+B.Turn the unit back over and set it
down on a flat surface.
3. Press and hold the PROGRAM button while lowering the Computer
Collar
®
unit from directly above the IndoorMicro Shields
®
transmitter.
4. Stop lowering when the Computer Collar
®
unit begins to flicker
yellow and release the PROGRAM button when the
Computer Collar
®
unit begins to flash green.
5. The Computer Collar
®
unit is now programmed to the desired
channel.
6. Verify operation by turning ON the Indoor Micro Shields
®
transmitter and listening for Computer Collar
®
unit activation.
Note: Make sure any Computer Collar
®
units you do not wish to program are more than 3 feet from the Indoor
Micro Shields
®
transmitter or have the Power Cap
®
Battery removed. Do not perform this procedure while the
Computer Collar
®
Unit is on a pet.
Operating Guide