User's Manual

www.petsafe.net 17

GETTING STARTED

4F Plug wire from interior frame into connector on the exterior frame.

4G Without pinching the wire frame, guide excess wire into space between

tip edge of door cut-out and tunnel on exterior frame. Align interior frame into

cut-out. View both sides of door to ensure the exterior and interior telescoping

tunnels are aligned.

Helpful Tip: You will be able to see clearly through all screw holes when your

door is aligned properly.

Insert Screws, Plugs, and Power Adapter

5A Thread mounting screws through interior frame. Be sure to insert screws

into screw holes inside battery compartment. Check to make sure pet door fit is

correct and frame is aligned flush, before tightening screws.

Note:

Small has 4 screw holes and Medium has 6 screw holes.

5B Insert finishing plugs into screw holes of interior and exterior frames. Align

flat edge of plugs with outer edges of frame. Plugs will only fit into frame in one

direction.

Optional:

Caulk around exterior frame for improved weather resistance.

Step

NOTICE

Use a manual screwdriver to tighten screws. Do not over-tighten.

Over-tightening can strip the screws or warp the pet door frame.