User's Manual

www.petsafe.net 7
Operating Guide
Step 1
Prepare the Handheld Remote
1. Using a small flathead screwdriver (or equivalent), place into the slot on the bottom and turn until the
top and bottom release (1A).
2. Install one (1) 3-volt (CR2032) battery under the clip, positive (+) side up (1B).
3. Firmly press the top and bottom back together (1C).
1C1A 1B
Replacement batteries (3-volt, CR2032) can be found at many retailers. Contact the Customer Care
Center or visit our website at www.petsafe.net for a list of common retailers.
Risk of explosion if batteries are replaced by an incorrect type. Do not short circuit,
mix old and new batteries, dispose of in fire, or expose to water. When batteries
are stored or disposed, they must be protected from shorting. Dispose of used
batteries properly.
Step 2
Prepare the Treat Dispenser
1. Remove the battery compartment door (2A).
2. Install four (4) AA batteries into the battery compartment on the
back of the Treat Dispenser (2B).
3. Replace the battery compartment door.
Risk of explosion if batteries are replaced by
an incorrect type. Do not short circuit, mix
old and new batteries, dispose of in fire, or
expose to water. When batteries are stored
or disposed, they must be protected from
shorting. Dispose of used batteries properly.
2A 2B