User's Manual

8 Customer Care Center 1-800-732-2677

4. Open the Hopper lid on the Treat Dispenser to size the

treats/kibble before ﬁlling. This Treat Dispenser requires dry treats

or kibble that can ﬁt through the dispenser. Round or oval kibble of

uniform size and shape work best, 1/2" size or smaller. The treat/

kibble size indicator is located inside the Hopper lid (2C).

For dry treats/kibble up to 1/2" size or smaller only.

5. Remove the Hopper by pressing the Hopper button. Locate the ramp in

the treat compartment. Move the ramp to correspond to the measured

treat size. If the kibble ﬁts into the cup labeled 1, the ramp needs to be

in the lower position (2D). In this position you should

be able to see the upper setting hole. If the kibble is

larger and ﬁts into cup 2, then the ramp must be

snapped into the upper position (2E). Note: The

ramp will be set by default from the factory in the

lower position for #1 size treats.

6. Once the treat/kibble size and ramp height have

been determined, ﬁll the Hopper to the ﬁll line (2F)

and close the hopper lid.

7. Press and release the power button on front of the

Dispenser to turn the Dispenser on. The LED’s will

light to indicate it is on and will display the battery status (see Battery Status

Indicator below).

8. The audible tone is on from the factory. Turn the tone switch off (on back of

Dispenser) if you prefer to train without it.

9. Press the button on the Handheld Remote to dispense the dry treats/kibble.

10. To turn the Treat Dispenser off, press and hold the power button for 3 seconds

or until the Red LED's turn off.

Battery Status Indicator

When turning on the Treat Dispenser, the LED surrounding the on/off button will indicate the battery

status in the following manner:

70-100% Battery

3 Green LEDs appear

for 3 seconds

40-70% Battery

2 Green LEDs appear

for 3 seconds

10-40% Battery

1 Green LEDs appear

for 3 seconds

1-10% Battery

3 Red LEDs appear for 1 second

then ﬂash for 2 seconds

2D 2E