Install guide

PG 6

PG 7

• “Fan out” wires as illustrated with CT30 below the wall

opening. As in the example: fan out the wires so that the

C wire is above the C terminal, the W above the W. This

allows the CT30 to t snug to the wall.

Caution

Do not allow wires to touch each other or parts on thermostat.

• Wires will position behind the CT30 and up over the

terminal area.

• Do not bunch wires behind the CT30. Feed any slack

back into the wall opening.

Connect Your Wires

• Connect labeled wires only to a terminal with the same letter label.

• Insert the wire in the terminal well and tighten the screw securely.

NOTE: If you wish you can mount the CT30 to the wall rst, and then connect the wires.

• The CT30 can be externally powered with a power source rated from 12V to 24V, AC or DC, at

300ma or greater. If used, connect to the C and RH terminals (no polarity).

urn

ace