Use and Care Manual

PG 12
MANUAL Screen Functions
The CT32 has 2 manual override commands. The manual screen is accessed by touching the large
current temperature display in the middle of the HOME screen.
IMPORTANT: The Mode must be in HEAT or COOL to access the manual screen.
TEMPERATURE Touch the +/- arrows to select your desired Target Temperature. This temporary
change in target will revert to the programmed target at the next time slot . Touch HOME to return to
operation.
EMER (in HEAT PUMP type)
If you set your CT32 for HEAT PUMP with auxiliary heat, EMER function is available on the MANUAL
screen. If you touch EMER, it displays EMER|ON. Your HEAT PUMP is disabled and auxiliary heat
is your sole source of heat. This manual override stays active until you toggle EMER off. Auxiliary
heat is more expensive than the heat pump so use EMER only if the heat pump cannot keep up or is
defective.
To use EMER heat automatically - If DIFF is set to 2F and RECOVERY is set to FAST, the CT32 will
use EMER heat automatically if the heat pump cannot keep up.