Use and Care Manual

PG 13
Other Functions
MODE Button - The mode button sets the CT32 to HEAT, COOL, AUTO, or OFF modes. Press
it once to step thruogh OFF to the next mode: HEAT -> OFF-> COOL -> OFF -> AUTO, etc. If the
CT32 is in OFF and you want to return to the mode you were previously in, touch the OFF indicator
on upper left of the screen.
FAN Icon - The fan control is normally in AUTO mode, meaning that the fan operates
automatically with the HVAC system and the thermostat. When the fan button is touched the fan
goes ON; the fan will run continuously in this manual override until switched back to AUTO by
touching the FAN icon again.
[NOTE: Fan ON function is available in the OFF mode to allow simple ventilating.]
RESET button - The RESET button re-boots the CT32 processor. It does not effect the target
temperatures that have been stored in permanent memory.
To reset the unit to factory default settings, go to OFF mode, touch the center of the screen for 6
seconds until 00 appears, then push reset.
Compressor Protection - The CT32 has a minimum cycle time of 4 minutes to protect your
compressor in cool and in heat pump (if you have one). The Home screen will show a hour glass and
“Please Wait...” during this time and the compressor will not come on until the 4 minute delay is over.