User's Manual

2-1
DataSonde
The Radiodetection DataSondes.
The DataSonde is installed in the drillhead/DataSonde housing.
To ensure optimum DataSonde performance and protection, the DataSonde should be securely fitted in
the drillhead/DataSonde housing. DataSondes may need minor modifications to ensure a secure fit.
O-rings or electrical tape are an acceptable means.
All Radiodetection DataSondes are constructed in three main sections.
Battery compartment
Batteries are inserted in the back end of the DataSonde with the positive end first. Always use ALKALINE
batteries.
Antenna
The antenna is positioned in the middle section of the DataSonde. The slots in the drillhead/DataSonde
housing should be positioned over the antenna section of the DataSonde to allow the electro magnetic
field from the DataSonde to be generated without any restriction.
Wrong positioning or length of the slots will effect the signal range and battery life of the DataSonde.
Electronics
The sensors for measuring the Roll (clock), the Tilt angle (Inclination), the DataSonde Temperature and
the Battery Status are located in the electronics section of the DataSonde.
The slot in the front end of the DataSonde fits the anti-roll pin in the drillhead/DataSonde housing
to stop the DataSonde from rotating inside the drillhead DataSonde housing, when drilling.
Battery Compartment
Antenna
Electronics