Installation Guide
Table Of Contents
- Title
- Contents
- Introduction
- System Description
- Pre-Installation
- Receipt of Equipment
- Site Planning
- Main Rack and Supporting Hardware
- Remote ACUs
- RFUs
- RadioBlades
- RAPs
- URU
- Interconnecting Cabling
- Main Rack Configuration
- RF Planning
- Site Survey
- Alarm Configuration
- Tools Required
- Installation
- Equipment Commissioning
- iDEN Interface
- Power Plant
- RadioFrame System
- Coverage Validation
- Site Acceptance Guidelines
- RadioFrame System Functionality Test
- RadioFrame System iDEN Functionality Test
- Interconnect & Dispatch Setup & Voice Quality
- Packet Data Service Connection and Latency
- Short Message Service
- Handover and Cell Reselection
- Interconnect Connection Stability and SQE Performance
- Dispatch Connection Stability
- Idle SQE Testing and Validation
- System Self-Recovery Test
- Packet Data Stability and Throughput
- Validation of ‘Unable to Key BR’ Alarm
- Rectifier & AC Power Alarms
- iSC-3 Functionality Test
- RadioFrame System iDEN Functionality Test
- Connecting the RFS to the Customer LAN
- Operations and Maintenance
- Appendixes
Method of Procedure
Equipment Commissioning
100 RFN_3.1 Beta
Table 5 Packet Data Latency over Motorola EBTS
T
est # Handset Carrier # RSSI
(dbm)
SQE
(dbm)
Ping
(No. of
Echos)
Router (IP
Address)
Average
Round
Trip Time
(msec)
Packet
Loss
(%)
1 100 xxx.xxx.xxx.x 0
2 100 xxx.xxx.xxx.x 0
3 100 xxx.xxx.xxx.x 0
4 100 xxx.xxx.xxx.x 0
5 100 xxx.xxx.xxx.x 0
5.6.1.3 Short Message Service
The Short Message Service (SMS) will be tested and verified by initiating the
delivery of a voice mail notification to the handset via one of the iDEN
RadioBlade links. Complete the following only if such testing is available via the
RFN customer’s web site.
1 Navigate on a network connection to the Internet.
2 Navigate to the RFN customer’s web site in the web browser.
3 On the RFN customer’s web site, enter the 10-digit phone number of the test
phone in the messaging field, which will display the mobile messaging page.
4 Enter a short text message into the field for message, and also enter a
subject in the subject line.
5 Press the Send button.
The message should appear on the test phone within a few minutes.
5.6.1.4 Handover and Cell Reselection
Handover and Cell Reselection shall be tested and verified that mobiles on the
RFS successfully handoff to the macro-cellular network during an interconnect
call. These tests shall also verify that mobiles on the RFS perform successful cell
reselection when in an idle state. The following table presents the data to be
collected for the handover and reselection tests.
Table 6 Handover & Idle Mode Reselection
Test
#
Handover (Mobile #) Carrier # from (HEX) Carrier # to (HEX)
1
2
3