Installation Guide
Table Of Contents
- Title
- Contents
- Introduction
- System Description
- Pre-Installation
- Receipt of Equipment
- Site Planning
- Main Rack and Supporting Hardware
- Remote ACUs
- RFUs
- RadioBlades
- RAPs
- URU
- Interconnecting Cabling
- Main Rack Configuration
- RF Planning
- Site Survey
- Alarm Configuration
- Tools Required
- Installation
- Equipment Commissioning
- iDEN Interface
- Power Plant
- RadioFrame System
- Coverage Validation
- Site Acceptance Guidelines
- RadioFrame System Functionality Test
- RadioFrame System iDEN Functionality Test
- Interconnect & Dispatch Setup & Voice Quality
- Packet Data Service Connection and Latency
- Short Message Service
- Handover and Cell Reselection
- Interconnect Connection Stability and SQE Performance
- Dispatch Connection Stability
- Idle SQE Testing and Validation
- System Self-Recovery Test
- Packet Data Stability and Throughput
- Validation of ‘Unable to Key BR’ Alarm
- Rectifier & AC Power Alarms
- iSC-3 Functionality Test
- RadioFrame System iDEN Functionality Test
- Connecting the RFS to the Customer LAN
- Operations and Maintenance
- Appendixes
RadioFrame System
Connecting to the Customer LAN
RFN_3.1 Beta 111
6.3 Configuring an Individual RAP
RadioFrame Access Points (RAPs) provide the 802.11b wireless interface
between the RFS and the corporate local area network (LAN). Typically, all RAPs
in the RFS are configured at one time using the 802.11 Global Configuration
options. These global settings can be overridden by changing configuration
information for individual RAPs. Individual RAPs can also be isolated from further
global changes as well.
NOTE: WEP Encryption and Enhanced Security settings override global 802.11
settings. Typically, changing these settings is done to isolate the RAP for testing.
1 Using the System Configuration tab, drill down to the RFU that contains the
RAP(s) you want to configure, and then select the RAP icon to display its
configuration page.
2 For SSID, either leave the globally configured SSID name as it is, or enter up
to 31 alphanumeric characters to change it.