Installation Guide
Table Of Contents
- Title
- Contents
- Introduction
- System Description
- Pre-Installation
- Receipt of Equipment
- Site Planning
- Main Rack and Supporting Hardware
- Remote ACUs
- RFUs
- RadioBlades
- RAPs
- URU
- Interconnecting Cabling
- Main Rack Configuration
- RF Planning
- Site Survey
- Alarm Configuration
- Tools Required
- Installation
- Equipment Commissioning
- iDEN Interface
- Power Plant
- RadioFrame System
- Coverage Validation
- Site Acceptance Guidelines
- RadioFrame System Functionality Test
- RadioFrame System iDEN Functionality Test
- Interconnect & Dispatch Setup & Voice Quality
- Packet Data Service Connection and Latency
- Short Message Service
- Handover and Cell Reselection
- Interconnect Connection Stability and SQE Performance
- Dispatch Connection Stability
- Idle SQE Testing and Validation
- System Self-Recovery Test
- Packet Data Stability and Throughput
- Validation of ‘Unable to Key BR’ Alarm
- Rectifier & AC Power Alarms
- iSC-3 Functionality Test
- RadioFrame System iDEN Functionality Test
- Connecting the RFS to the Customer LAN
- Operations and Maintenance
- Appendixes
RadioFrame System
Operations and Maintenance
RFN_3.1 Beta 125
Indication Possible failure Corrective action
If the fan is not working, unplug
the ACU and contact Customer
Support.
RJ45 port Link and
Activity LEDs are not lit,
or the Activity LED is not
blinking
connection is not being
made between RFS
components
For the affected port, verify that
all cabling between
components is properly
connected.
7.3.3.3 RadioFrame Unit
The RadioFrame Unit (RFU) has two RJ45 ports on the top of the back cover of
the unit: MAIN and AUX. Only the MAIN port is used. The AUX port has a
protective cover that must not be removed. During installation, ensure that the
RFU is receiving power and connectivity from the ACU before inserting
RadioBlades into the RFU or placing the front cover on the RFU.
Warning!
Do not remove the protective cover from or insert a connector into the AUX port. This will
cause damage to the RFU, the ACU, or both.
The MAIN port has two LEDs: Link (right) indicates Ethernet connectivity, and
Activity (left) blinks to indicate Ethernet activity between the RFU and the ACU.
For all other conditions, refer to the following table.
Indication Possible failure Corrective action
MAIN Port LEDs do not
light
connection is not being
made between the RFU
and the ACU
Verify that all cabling between
the ACU and the RFU is
properly connected.
Verify that the ACU is powered
on.
Contact Customer Support.
7.3.3.4 Universal Repeater Unit
The Universal Repeater Unit (URU) has two pairs of RJ45 ports on the front of
the unit. Each pair (IN/OUT) indicates Ethernet connectivity and activity between