Installation Guide

RadioFrame System
Operations and Maintenance
RFN_3.1 Beta 135
Alarm Description Action
NET POOL ERROR The free Mblock cluster has gone below 40
on an NPC or AP, the threshold for
APC_NETPOOL_LOWMARK or
NPC_NETPOOL_LOWMARK.
Causes a system reset.
OVERTEMP A chassis has overheated. Check the chassis for
proper operation.
PEER LOSS Communication with a board has been lost.
RIC has detected a PEER LOSS from the
RLIC.
Causes a system reset, unless the cause is
a DHRB, which self resets.
PLL LOCK A RIC or RLIC PLL went out of lock.
The RLIC locks and de-key all BRs, and
then sends a state change trap to the iSC.
RB ALARMS-CRC An RB has generated a RIC CRC error
within the last 30 minutes.
Monitor the RB/RFU
and if it keeps
incrementing, replace
the RB/RFU.
RB ALARMS-MISC An RB has generated a RIC error other than
the CRC error.
If this alarm occurs
frequently while the
system is running,
monitor the RIC.
RB CALIBRATION The RB did not reset after three attempts
due to a Bad VGA.
Identify the RB and
replace it.
RB E2 READ ERR RBSession EEPROM read attempts have
failed beyond threshold.
The RB goes into an error state.
Replace something.
RB ERROR STATE The RB has gone into an error state
because there was either an error reading
I/Q DAC values, or the values were invalid.
Identify and replace the
RB.
RB SLOT MISS APC has detected an RB in the wrong slot.
APC sends a message to the RIC with the
RBIndex.
Causes slot synchronization for the RB.
RB SYNC FAIL Three consecutive attempts to sync up the
RB failed.
Reset the SPAM.
RB TX GAIN CAL
ROM MISMATCH Board boot version is not the same as the
RLIC.
SPAM FAILED Lost DSP PDUs have exceeded threshold.
SPAM is reset.
SW VER MISMATCH Board software version is not the same as
the RLIC.
SYSTEM RESET Alarms that result in a system reset cause
thi l t f th RLIC