User's Manual

Proprietary and Confidential Information

MC-Series Standard Capacity system998-1019-01 Rev X1

a. Do not jam the board in any way while inserting it.

b. Do not mount the board in any orientation other than that specified in the

diagram.

c. Insert the board straight into the chassis unit so as not to damage any

components contained on the board.

d. Press firmly to seat the board into the connectors within the chassis unit.

e. Tighten the blue knurled knobs on each end of the board finger tight

only—do not use a screwdriver to tighten the screws and do not over

tighten.

5. Place the old board in the antistatic packaging for shipment.

6. Using the breakers on the PDU, turn up the ABIC and DRBS and then verify

that the components are operational before proceeding.

a. Wait approximately 3 minutes for the following indicators:

DRBS:

• The STATUS LED for each group will turn green in this order: A, B, and

then C.

• The RADIOBLADE TRANSCEIVER STATUS LEDs will turn red and then

green for each present RadioBlade transceiver. If no RadioBlade

transceiver is present, the LED will not light. To verify the contents of the

DRBS, pull out the shelf (powering off is not required) and inspect the

RadioBlade transceivers and their respective status LEDs. Reinsert the

DRBS. To do this, press up on one side rail locking arm and press down

on the other side rail locking arm, and then push the unit into the cabinet.

For an illustration of the locking arms, refer to Figure 9.13.

ABIC CRIC:

• The POWER and STATUS LEDs will turn red and then green. All other

ABIC card LEDs will turn green.

7. Using the breaker on the PDU, turn up each RF Shelf and then verify that each

RF Shelf is operational before proceeding.

Note: The POWER and ALARM LEDs on the front of

the RF Shelf will turn green.