User's Manual

Proprietary and Confidential Information

MC-Series Standard Capacity system998-1019-01 Rev X1

Figure 4.2 Connections between the iSCIII and ABIC

4.1.2 EAS

Note: You need to install an EAS. Therefore, follow this

procedure:

1. While supporting the EAS, slide the EAS into the cabinet mounting position.

2. Mount the EAS in the location shown in Figure 4.1.

3. Secure the EAS to the cabinet mounting rails using the four mounting screws

provided with the unit. Tighten the screws to 4.5 Nm (40 in-lb).

4. Connect the RadioFrame Networks-provided ground cable (P/N 820-0609-10;

EAS to GND BAR) between the cabinet ground bar and the grounding lug on

the rear of the EAS, and ensure the connection is tight.

5. Connect the RadioFrame Networks-provided power cable (P/N 820-0616-50;

EAS to PDU-EAS) between the EAS power and the EAS circuit breaker on the

PDU.

6. Connect EAS to each iSCIII according to installation procedure.

7. Refer to Figure 4.3. Connect the RadioFrame Networks-provided contact

closure alarm wires from the CONTROL port on the EAS (RJ-45) to the

STATUS connectors on the PDU (Molex).