User's Manual

Preparing for the Installation
5
Figure 5 Each RadioBlade supports one standard platform including GSM,
CDMA, iDEN, 802.11b (WLAN), and many others.
Tools and Parts Required
The RadioFrame System comes with all the parts necessary to mount each
component of the system. Tools required to mount the system components are as
follows:
• #2 Phillips screw driver
• For RFU ceiling mounts, drill with 3/16” bit for use with provided wood
screws, or a 9/32” bit and four ¼” bolts (not provided)
Safety Precautions
Read all the notices in this section prior to installing or using the RadioFrame
System or any of its components, including the Network Chassis Unit (NCU),
Airlink Chassis Unit (ACU), RadioFrame Unit (RFU), or RadioBlade.
Safety Recommendations
• Keep tools away from walk areas where you and others could fall over them.
• Wear safety glasses if you are working under any conditions that might be
hazardous to your eyes.