User's Manual

Installing the RadioFrame System
22
5 Remove the anti-static wrist strap and place the front cover on the RFU.
Figure 13 Slide each RadioBlade into the specified slot in the RFU.
Verify the System
During the installation, each component of the system is verified for power and
connectivity. Assuming that each system component—NCU, ACU, and RFU—
has been properly installed and is receiving power, double check that all Power,
Status, Link and Activity LEDs throughout the system are lit and are green
(Activity LEDs on all RJ45 ports should be blinking rapidly). For any other
condition on any system component or connection, refer to “Troubleshooting.” If
necessary, refer to “About This Guide: Obtaining Service and Support.”