Operating instructions

NETGEAR Wireless N150 Access Point WN604 Reference Manual
Introduction 1-7
v1.0, March 2010
Table 1-1. Front Panel LED Indicators
Item LED DESCRIPTION
1Power Power Indicator
OFF No power.
Solid
Amber
AP performing the power on self-test diagnostic.
Solid
Green
Power ON and AP ready
Blinking
Green
Firmware upgrade in process
2W-Fi WPS
Function
WPS LED
OFF There is no WPS activity or WPS error and the AP is not in the temporary
AP setup locked state
Blinking
Green
There are WPS activities.(0.5 sec on and 0.5 sec off)
3 802.11b/g/N WLAN LED
Blinking
Blue
Data transmission or receive activity occurs through the wireless
Solid Blue Wireless is up and running without wireless data transmission
OFF Wireless Interface is turned off
4 4* 10/100 LAN Link/Active LED
OFF No link detected.
Solid
Green
100 Mbps link detected, no data transmission on the port.
Blinking
Green
100 Mbps link detected, data transmission on the port.
Solid
Amber
10 Mbps link detected, no data transmission on the port.
Blinking
Amber
10 Mbps link detected, data transmission on the port.