User Manual

How to match code with transmitter:
1. Place the transmitter and the receiver close to each other within 1 meter.
2. Turn on the transmitter, then power on the R6DS.
3. Connect R6DS to ESC or flight controller or servo.
4. There is a black button on the R6DSM, press the binding button in one second until the receiver light
starts blinking and release, after about 8 times blinking, match code success when receiver signal LED
always on.
Installment of receiver antenna：
1. The antenna must be kept as straight as possible. Otherwise it will reduce the effective range.
2. Large model aircraft may of some metal part interfering signal, in this case the antenna should be
placed at side of the model.
3. The antenna must be kept away from conductive materials, such as metal and carbon by at least a half
inch. The coaxial part of the antenna does not need to follow these guidelines, but do not bend it in a
small radius.
4. Keep the antenna away from the motor, ESC, and other noise sources as much as possible.
5. The receiver can be packed by sponge or foam for shocking proof when it is installed to the model.
After all of the above steps finished, now the program functions to assure it under control of transmitter
with a right connection.
Specification:
1. Channels: 6 channels when work as PWM mode. 10 channels when work as SBUS/PPM mode.
2. Working voltage: 4.8-6V
3. Working current: 38-45mA（input voltage: 5V）
4. Size: 25*15mm
5. Weight: 3.5 grams
6. Detachable antenna
7. 4096 section precision, 0.25us per section, servo anti-shake rudder.
8. Control distance: about 600 meters, actually control distance depends on the environment.