Data Sheet

R6DSM

(FHSS and DSSS spread spectrum)

Radiolink R6DSM, 2.4G 10 channels receiver, DSSS and FHSS spread spectrum working

synchronously, 1 gram weight, SBUS and PPM signal support, use for Radiolink transmitters AT9,

AT9S，AT10 and AT10II, is the best choice for racing drone.

PAGE 1
R6DSM (FHSS and DSSS spread spectrum) Radiolink R6DSM, 2.4G 10 channels receiver, DSSS and FHSS spread spectrum working synchronously, 1 gram weight, SBUS and PPM signal support, use for Radiolink transmitters AT9, AT9S，AT10 and AT10II, is the best choice for racing drone.
PAGE 2
Two signal working mode: Blue/purple LED, SBUS signal , 10 channels totally. Red LED always, PPM signal, 10 channels totally. SBUS and PPM signal change: Short press the ID SET switch two times within 1 second, the signal is changed from SBUS to PPM. The red LED indicates the PPM and blue/purple indicates SBUS. How to match code with transmitter: 1. Place the transmitter and the receiver close to each other within 1 meters. 2. Turn on the transmitter, then power on the R6DSM. 3. Connect CH3 of R6DSM to ESC.
PAGE 3
2. Large model aircraft may of some metal part interfering signal; in this case the antennas should be placed at both sides of the model. Then the best RF signal condition is obtained at any flying attitude. 3. The antennas must be kept away from conductive materials, such as metal and carbon by at least a half inch. The coaxial part of the antennas does not need to follow these guidelines, but do not bend it in a small radius. 4.