User's Manual

Adjustability:

• Three logic switches can be used. (LSW1, LSW2, and LSW3 )

• SW(1): Any SWICH A-H or THRSTKS, SW(2): Any SWICH A-H

• Switch position (POSI)

• Logic mode: AND or OR (MODE)

2.3.15 SERVO display and cycle submenu:

Displays radio's output to channels 1-10.

The servo submenu includes two features:

• real-time bar-graph display to demonstrate exactly what commands the transmitter is sending to the servos.

(This can be particularly handy in setting up models with complicated mixing functions, because the results

of each stick, lever, knob, switch input and delay circuit may be immediately seen.)

• servo cycle function to help locate servo problems prior to in-flight failures. (channels 1-8)

Goals Steps Inputs

View the result o f

reassigning channel 6

from VR(A) knob to

three-position

SWITCH C

Cycle the channel 6

servo.

Complete desired programming

function.(Ex: in AUX-CH,move ch.6 to

See AUX-CH for d etails.

Open SERVO function

for 1s .(If ADVANCE again) .

to SERVO ,PUSH

Move each control to see the

operation.(Ex: SWITCH C in all positions)

C to center position.Note change in

position of ch.6 servo.

Prepare all servos to be cycled and cycle

Plug in servos. Power on.

2.3.16 TELEMETARY

Signal strength and receiver voltage integrated into the radio transmitter. It is displayed as the following

configure, also it is in the sub menu RECEIVE.

Receiver voltage is shown as RX,

External voltage is shown as EXTY.