User's Manual

10
（
3
）
Helicopter servo connection
The above listed receiver and channels is referred to the channel 1~9 of the receiver R9D, connect the
receiver with the related servo, you can control t he servos by the correspondent switch.
To be clear, the servo connected with the r eceiver channel 1 is controlled by the radio aileron lever; servo
connected with channel 2 is controlled by elevator lever; servo connected with channel 3 is controlled by
throttle stick; servo connected with channel 4 is controlled by the rudder lever. Channel 5~9 can be self-set
with the related switches by the menu AUX-CH, and the sub menu. For channel 9, the LED indicator on the
receiver flashes red for S-BUS signal and blue for PPM.
Receiver all channels shows:
Receiver out
p
ut
and channel
Helicopter
1
aileron/cyclic roll
2
Elevator/cyclic pitch
3
Throttle
4
Rudder
5
Spare/gyro
6
Pitch(collective pitch)
7
Spare/governor
8
spare/mixture control
9
Spare
10
spare
CH1(AILE)
CH2(ELEV)
CH3(THRO)
CH4(RUDD)
CH5(GEAR)
CH6(FLAP)
CH7(AUX1)
CH8(AUX2)
RECEIVE INTERFACE