User's Manual
11
1.2.3 Installment of antenna
(1) Installment of receiver antenna
1. The antenna must be kept as strai
g
ht as possible. Otherwise it will reduce the effective ran
g
e.
2. Lar
g
e model aircraft ma
y
of some metal
p
art interferin
g
si
g
nal; in this case the antennas should be
placed at both sides of the model. Then the best RF signal condition is obtained at any flying
attitude.
3. The antennas must be ke
p
tawa
y
from conductive materials, such as metal and carbon b
y
at least a
half inch. The coaxial part of the antennas does not need to follow these guidelines, but do not
bend it in a small radius.
4. Keep the antennas awa
y
from the motor, ESC, and other noise sources as much as possible.
5. Press and hold the Eas
y
Link
(
ID SET
)
one second, now the receiver starts work.
6. After all of the above ste
p
s finished, the LED indicator will turn and kee
p
in red.
The receiver can be packed by sponge or f oam for shocki ng proof when it is installed to the model
△
△
!
After all of the above steps finished, turn off the transmitter and then power it on, now the program
functions to assure it under control of transmitter with a right connection
(2) Installment of transmitter
1. The t ransmitter antenna is ad
j
ustable so
p
lease make sure that the antenna is never Pointed directl
y
at the model when flying as this creates a weak signal for the receiver.
2. Kee
p
the antenna
p
er
p
endicular to the transmitter's face to create a better RF condition f or the
receiver. Of course this depends on how you hold the transmitter, but in most cases, adjusting the
transmitter antenna so that it is perpendicular to the face will give the best results. Please adjust the
transmitter antenna to the way you hold the transmitter.
3. Never
g
ri
p
the antenna when fl
y
in
g
as this de
g
rades RF
q
ualit
y
.
1.3 RADIO BASIC SETTING
1.3.1 Basic setting of the transmitter
1. Dis
p
la
y
lan
g
ua
g
e: can be selected the dis
p
la
y
lan
g
ua
g
e of the function name, etc. in each function menu.
The screen reads "LANGUAGE". Change this to the desired language.
2. Stick Mode: The screen reads "STK-MODE". Chan
g
e this to the correct mode. Note that this will NOT
change the throttle and elevator rachets, etc. Those are mechanical changes that must be done by a
service center.
3. RF Mode: t he LED indicator will become solid
g
reen when RF Mode is active.
CH9
VCC INTERFACE
GND INTERF ACE
VCC
GND