User's Manual

15
This guide i s intended to help you acquainted with the radio, t o give you some ideas and direction on
how to do.We give you a big picture overview of what we accomplish; a ‘by name’ description of what
we’re doing to help you with the radio; then a step-by-step instruction to leave out the mystery when
setting up your model.
For additional details on each function,see that function’s section in this manual.
Goals of Example Steps Input for Example
Prepare your
airplane
Install all servos,switched,receivers,etc.per your model’s instructions.Turn on
transimitter then receiver;adjust all linkages so surfaces are nearly
centered.Mechanically adjust all linkages as close as possible to proper control
throws.Check servo direction.Make notes now of what you will need to change
during programming
.
Name the model
(Note that you do
not need to do
anything to ‘save’
or store this data).
Open the Basic menu,then
open the PARAMETER
T
urn on the transimitter.
for 1second to basic menu. to choose model
Go to Model Name
to Mode， to Mode name，press PUSH to
setting
Input airplane’s name
Close the Model submenu
to change first character,when proper character is
displayed,push
to select. to move to next
character.Repeat as needed.
return to BASIC menu
Need to adjust EN
D-POINT to meet
with the related ser
vo.
In the BASIC menu find the
END POINT
to END POINT，press to set
Adjust end point (EX:
THRO servo)Close the
function
to Throttle Throttle stick until carburetor
closes as desired.
until throttle arm just open
carburetor at fully throttle stick.Repeat for each
channel as needed.
With digital trims you don’t shut the engine off with THROTTLE TRIM.Let’s set up IDLE-DOWN and ‘throttle cut’
Goals of Example Steps Input for Example
Idle down setting: Idle
down is to lower the en
gine speed for landing,
snap rolling scrobatic
display, and launching
etc. It is preset OFF an
dmainlyusedtostarte
ngine and glide, then t
o avoid flameout.
From the BASIC menu choose IDLE
DOWN.
to IDLE DOWN，press
Activate and adjust IDLE DOWN
to MIX，press ， to ON，press
C to center position.,screen now reads
ON.
to RATE,to increase rate until engine
idles reliably but low enough to sit still .
Optional:change switch C command
to POSI，press ， as you desired
press
Close the function
BASIC menu， again to startup
screen.
THR CUT shuts the
engine offcompletely
From BASIC menu, choose THR CUT
to THR CUT，press