User's Manual

20
THROTTLE DELAY.
Goals Steps Inputs
Decrease the flap servo
throw in the upward
direction to 5% to allow
trimming of level flight
only and down travel to
85% to prevent binding.
Open END POINT function
for 1s.(If ADVANCE, again）
to END POINT,PUSH
Choose proper channel and move
stick or Knob in direction you
want to adjust and set servo throw
(Ex:flap up 5%)
to FLAP，PUSH， to 5%，press
Close
2.3.4 Trim
TRIM submenu: resets and adjust effectiveness of digital trims.
【
TRIM
】
RESET
：
Execute
STEP-AILE
：
4
（
0
）
ELEV
：
4
（
0
）
THRO
：
4
（
0
）
RUDD
：
4
（
0
）
The AT9 has digital trims which are different from conventional mechanical trim sliders. Each TRIM
LEVER is actually a two-direction switch. Each time the TRIM LEVER is pressed, the trim is changed a
selected amount. When you hold the TRIM LEV ER, the trim speed will increase. The current trim position is
graphically displayed on the start up screen. The TRIM submenu includes two functions that are used to
manage the trim options.
（1） Trim reset
(
RESET
)
: Electronicall
y
centers the t rims to their default values. Note that the
SUB-TRIM settings and the trim STEP rate are not reset by this command.
（
2
）
Trim step (STEP): changes the rate at which the trim moves when the TRIM LEVER is activated.
It may be set from 1 to 40 units, depending on the characteristics of the aircraft. Most ordinary
aircraft do well at about 2 to 10 units. Generally larger trim steps are for models with large
control throws or for first flights to ensure sufficient trim to properly correct the model. Smaller
trim steps are later used to allow very fine adjustments in flight.
HELI models only: OFFSET is available in the idle ups. If OFFSET is inhibited, adjustment of the TRIM
LEVERS will adjust t he trims for all flight conditions. If OFFSET is active, then moving the trims within
any one condition will affect only that condition.
Goals Steps Inputs
Reset trims to neutral after having
adjusted all linkage.Note: this is
one of the several functions for
which the radio requires
confirmation to make a change
Open BASIC menu,
then open TRIM
submenu.
for 1s.(If ADVANCE, again）
TRIM .
Confirm the reset.
to reset, for 1s. Beep sounds.
Double the sensitivity of the
AILERONTRIM LEVERS for a
first flght of an aerobatic model to
ensure sufficient range to trim the
model for level flght.
Adjust the size of
thestep (Ex：8）
to AILE，PUSH， to 8,PUSH
Repeat for other
channel.
to ELEV,PUSH to new setting.
Repeat as needed.
Close
2.3.5 SUB TRIM