User's Manual

24
Optional:assign dual rates to
have one for each condition.
to SW,PUSH. to Cond.
Repeat steps above to adjust for each condition.
Goals Steps Inputs
Set up aileron triple rates on
SWITCH C with travel
settings of 75%(normal)
25%(slow roll)and 140%
(extreme aerobatics)and
exponential setting of 0%,
+15%, and -40% respectively.
NOTE: This normal rate has
no exponnential so it has a
very linear,normal feel. This
is slow roll rate has positive
exponential(the opposite of
what most people normally
uses), which makes the
servos more responsive
around center.This makes the
servos feel the same around
center in the normall and
low rates,but still gives a
very slow roll rate at full
stick.
The 3D rate(extreme
aerobatics )has a very high
distance of travel nearly
twice that of the normally
rate. Therefo re, using a very
high rate negative
exponential setting softens
how the servos reponse
around center stick.
Open D/R,EXP
for 1s to BASIC（ to D/R,EXP,PUSH.
Choose channel to change
(Ex:aileron is already selected)
to CH,PUSH， to AILE,PUSH
Optional:Change switch position.
to SW,PUSH to SWC,PUSH
Confirm switch is in desired
position and set rate.(Ex:up=high
rate,75%
)
to D/R C to UP position.
AILERON STICK to75%.PUSH
AILERON STICK to75%.PUSH
Move Switch to 2nd rate position
and set this particular rate
(Ex:center=low rate,25%)
SWC
to center positon,
to D/R
AILERON STICK to25%，PUSH
AILERON STICK to 25%，PUSH
Optional:if using a 3 positon
SW,move SW to 3rd positon and
set this rate.(Ex:DOWN=3D rate,
140%)
SWC to DOWN position.
AILERON STICK to140%，PUSH
AILERON STICK to140%，PUSH
Optional: except using a switch,
you can set high rates to be
triggered when the stick moves
past a certain point. To test this,
set aolero high rate to 25%.Now
set switch assignment to
AIL(90%). Move AILERON
STICK to the right and notice the
huge jump in travel after the sitck
moves 90% of its distance.
to SWA to AILE(90%)
,
PUSH
to D/R
AILERON STICK to 25%
AILERON STICK to 25%
AILERON STICK and watch screen
graph.See the change? You may also
change the trigge r point by holding the stick
at the desired point then pressing and
holding the PUSH.
Set each rate’s EXP.
(Ex：0%，+15%，-40%）
to EXP .PUSH
C to UP position confirm EXP reads 0.
C to DOWN position.
AILERON STICK to+15% .PUSH
AILERON STICK to+15%.PUSH
C to center position
Repeat to set low rate EXP to -40%.
Repeat above steps for elevator and rudder.
Close
2.3.8 Throttle Cut
AEROBASIC
Throttle cut (THR-CUT) (ACRO0/HELI): provides an easy way to stop the engine by flipping a switch