User's Manual

25
(with THROTTLE STICK at idle). The movement is largest at idle and disappears at high throttle to avoid
accidental dead sticks. In HELI, there is an additional setting.
The switch's location and directio must be chosen. It defaults to NULL to avoid accidentally assigning it to
a switch, which might result in an unintentional dead stick in flight.
【
【
THR CUT
】
MIX
：
INH
RATE
：
0%
THR:5%(100%)
SW
：
SwH
POST
：
DOWN
Goals Steps Inputs
Decrease the throttle
setting(at idle) to stop the
engine with the flip of a
switch.(NOTE that you
MUST assign a
switch.The default is
NULL.We recommend
SWICH C in the down
position,with
IDLE-DOWN
programmed to SWITCH
C in the center and down
position.)
Open BASIC menu, then Open
THR CUT
for 1s .(If ADVANCE again) .
to THR CUT. PUSH.
。
Activate the function .Choose
desired switch, and the position
which activates the function.
to MIX,PUSH, to ON，PUSH
to SW,PUSH, SWC，PUSH
to POSI,PUSH to DOWN,PUSH
With Throttle Stick at idle,adjust
the rate.
SWC to DOWN position.
Until the engine consistently shuts
off but throttle linkage is not
binding.
Throttle Stick.
to Rate. until shuts off.
Close
*Also LOGIC SW(Lsw1 to 3) may be assigned.
** Normally, a setting of 10-20% is sufficient. Viewing the carburetor barrel until it fully closes is adequate
to get an approximate setting; then test with engine running to confirm.
GLIDER
Provides an easy way to stop the engine by flipping a switch no matter where the air brake stick is. The
movement of servo will be -30%. Now you must select switch position and direction. Factory setting the
position i s NULL t o avoid an accident setting on a switch to cause glitches during flight.
Adjustability:
• Range: -30% to +30%. Movement of servo is 0%, air brake stick is on its min and -30% on the max.
• SWA-H and logi c switch Ls1-3 is selectable
• All position is available for logic switch including NULL (usually MIX OFF), you can set MIX by
different position of a switch (UP & Cntr, Cntr & Dn) and also NORM, REV.
Goals Steps Inputs
Flip switch to
decrease the rate until
engine stops.
(NOTE:you MUST
assign a switch to
control which default
is NULL)
Open BASIC menu ,then open THR CUT
for 1s .(If ADVANCE again) .
to THR CUT. PUSH.
Activate the function Choose desired
switch, and the position.
to MIX,PUSH, to ON，PUSH
to SW,PUSH, to desired SW，PUSH
to POSI,PUSH to desired
position,PUSH
Adjust Rate until the engine shuts off.
to Rate. until shuts off.
Close