User's Manual

2
Note:About flying
While you are getting ready to fly,if you place your transmitter on the ground ,be sure that the
wind won’t tip it over. If it is knocked over, the throttle stick may be accidentally moved, causing the
engine to speed up. Also, damage to your transmitter may occur.
Other than 2.4GHz system: Before taxiing, be sure t o extend the transmitter antenna to its full
length.collapsed antenna will reduce your flying range and cause a loss of control.It is a good idea to avoid
pointing the transmitter antenna directly at the model, since the signal is weakest in that direction.
In order to maintain complete control of your aircraft it is important that it remains visible at all times .
Flying behind large objects such as buildings, grain bins, etc. is not suggested. Doing so may result in the
reduction of the quality of the radio frequency link to the model.
2.4GHz system: DO not grasp the transmitter module’s antenna during flight.Doing so may degrade the
quality of the radio frequency transmission.
2.4GHz system: As with
all radio frequency transmissions, the strongest area of signal transmission is from
the sides of the 9 shift transmitter module's antenna. As such, the antenna should not be pointed directly at
the model.If your flying style creates this situation,easily move the antenna to correct this situation.
Warning!!!
please don't fly in the rain! Rain or moisture may enter the transmitter internal through gaps in the antenna or
joystick flight and cause your flight to instability even out of control. If inevitable will fly in the wet weather
(such as game), please be sure to use plastic bags or waterproof cloth to cover your transmitter, please don't flight
if there is lightning.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void
your authority to operate the equipment.