User's Manual

Adjustability:

• Plug the gyro's sensitivity adjustment to channel 5, 7, or 8 of the receiver. (selectable)

• Full switch assignable (SWITCH A-H)

• Each rate setting may be set from 0 to NOR100% or AVC100% gain. NOR: GY mode gain. AVC: STD

mode gain

• Larger percentages indicate more gain, or gyro responsiveness.

• MIX-1,2: Two surfaces' sensitivity can be adjusted independently.

GYRO GAIN ADJUSTABILITY:

•

When the servo hunts, the gyro gain is too high. Lower the gain until the hunting stops.

• The gyro will display best performance at a gain just before hunting occurs. Perform adjusting by flying

the aircraft r epeatedly.

Precaution:

• When taking off and landing, always switch to the Normal mode. Taking off and landing in the GY mode

is dangerous.

•

We recommend that you use the rudder control gyro in the Normal mode. In the GY mode, rudder operation

is necessary when turning because the weathervane effect is lost. Use the gyro in the Normal mode unless

you are an expert in rudder operation.

• And we recommend that you also set to off (0%) mode for safety as follows.

Goals Steps Inputs

Set up a

GYA gyro

setting

(Ex:MIX-1)

Open GYRO-SENSE

to BASIC . again to ADVANCE

to GYRO-SE NSE,

Activate the function.

to MIX-1.PUSH to ON.

Optional: change switch assignment.

Ex: select E.

to SW.PUSH. to SwE

Adjust gyro rates as needed.(Ex: UP to

NOR70%,CNTR to 0%[off], DOWN to

AVC70% as starting points.

to gyro rate.Push. E up. to NOR 70% ，

EtoCNTR, to 0%， E DOWN， to

AV C 7 0 %

3.3.13 THR-DELAY (ACRO):