User's Manual

52
REVERSE servos as needed for
proper control operation.
In the BASIC menu, open
REVERSE.
to REVERSE.
Choose desired servo and
reverse its direction of
travel.
(Ex:reverse rudder servo.)
to 4.RUDD, REV is highlighted. for 1
sec. ‘Are you sure?’Displays.
to confirm.
To BASIC menu.
Adjust travels as needed to
match model’s recommended
throws (usually listed as high
rates).
In BASIC menu choose
END POIN T.
to END POINT.
Adjust the servos’ end
points. (Ex: flap servo).
Close the function.
to FLAP
VR(A). ， to desired travel.
VR(A). ， to desired travel.
Re
p
eat as needed.
Choose D/R,EXP
to D/R,EXP
Set up dual/triple rates and
exponential (D/R, EXP).
(Note that in the middle of the
left sideof the screen is the name
of the channel and the SWITCH
position you are adjusting. Two
or even three rates maybe set
per channel by simply choosing
the desired SWITCH and
programming percentages with
the SWITCH in each of its 2/3
position.)
Choose the desired
control, and set the first
(Ex: high) rate throws and
exponential.
to CH ， to CH2(ELEV).
A to UP position.Screen reads ELEV [UP]
to D/R
Elevator Stick. ， to set .
Elevator Stick. to set.
（Normally the same for both direction）
to EXP
Elevator Stick to set
Elevator Stick to set
Set the second (Ex: low)
rate throws and
exponential.
to D/R ， A to down position. Repeat
above to set low rate.
Optional: change dual
rate SWITCH assignment.
Ex: elevator to SWITCH
G with 3 positions.
to SW ， to G， G to center.
Repeat steps above to set 3rd rate.
Move flap control from the (VR
(A)) dial to the left slider.
[VR(D)](AUX -CH) .
In the BASIC menu, open
AUX-CH.
to AUX-CH
Choose CH5. Change
primary control to VR(D).
Change other channels as
needed.
to CH5 ， to VR(D)。
Repeat steps above to set other channels.
Close
4.2 SET GLID TYPE
TYPE: (GLID 1A+1F), GLID (2A+1F), GLID (2A+2F)