User's Manual

4.3.5 START DELAY (GLID 1A+1F only):

START DELAY automatically switch the offset trims (OFFSET) from the START condition's trims to the

normal condition’s trims after proceeding the delay time (max.10sec.) which is set by the -dly- item when

activating the START condition. (It is convenient for hand launch glider.)

Note: The same delay amount for elevator and rudder i s recommended when using V-tail function.

ADJUSTABILITY:

• Delay time (-dly-) range of 0 to 100%. The delay time is 10 second at 100%.

Goals Steps Inputs

Ex: delay time=5

second.

Open ADVANCE

menu,then open START

DELAY.

to BASIC . again to ADVANCE

to START-DLY,

Activate the function

to MIX ， to OFF or ON

Set the delay time.

(Ex:50% each surface)

to ELEV ， to 50%

to RUDD ， to 50%

Repeat as needed.

4.3.6 CHAMBER-FLP

CAMBER FLAP assigns the primary flap control [defaults to VR(A)] to allow trimming in flight of the flap

action. The up and down travel of each flap (camber flaps: FLP1/2) can be adjusted independently. Also the

center position of flap servo can be offset.

Note: If FLAP-TRIM is activated, you can not use CAMBER FLAP function simultaneously.

ADJUSTABILITY

•

Rate: -100% to +100%, with a default of +30%

• Center position (CENTER): The operation reference point of flap can be offset. -100% to +100%, with a

default of 0%.