User's Manual

58
Activate BUTTERFLY.
Adjust the aileron a nd
flap travel to 75%
Elevator settin
g
are
a
dj
usta
bl
e
i
nt
h
e
B
.
FLY
-
ELE
.
MIX switch is selecable
Open the BUTTERFLY
function
to BASIC . again to ADVANCE
to BUTTERFLY,
Activate the function
SWA to UP position
to MIX ， to OFF
Adjust the travels as
needed.
(Ex: Aileron each 75%,Flap
75%)
to AIL1 ， to 75%，
to FLP ， to75%，
to AIL2 ， to 75%，
Close
4.3.9 AILE/ RUDD MIX
You can select a pre-programmed mix which is used to mix the rudders with aileron operation or the ailerons
with rudder operation.
Aileron-to-rudder mix (AILE RUDD): automatically creates a "coordinated turn".
Rudder -to-aileron mix (RUDD AILE): used to counteract undesirable roll (roll coupling) that happens
with rudder input, especially in knife-edge.
ADJUSTABILITY:
• RATE range of -100 to +100. Negative setting would result in opposite rudder (aileron) action from aileron
(rudder).
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate the
mix in 2 separate positions of the same SWITCH.
• Condition: The separate AILE RUDD setting for each flight condition can be set.
Goals Steps Inputs
Ex:RUDD-AILE,
25%,no
switch,corrects
roll coupling.
Open AIL/RUD-MIX
submenu.
to BASIC . again to ADVANCE
to AIL/RUD-MIX,
Select the mixing mode.
to MODE ， to RUDD-AILE
Activate the function
to MIX ， to ON
Set the rate (Ex:100%
each way)
to RATE
RUDDER STICK ， to +25%
RUDDER STICK ， to +25%
Close
4.3.10
ELEV-FLAP mixing (see GLID menu 3.3.7)
4.3.11 AILE-FLAP(GLID 2A+2F only):