User's Manual

62
Input name.
to change the first character.
Close the submenu when
done.
When proper character is display.
to next. Repeat.
Goals Steps Inputs
Reverse servos as needed for
proper control operation.Ex:
Left Rudder Stick results in
leading edges of tail rotor
blades moving left.Reverse to
operate properly.
In BASIC menu, open
Reverse.
for 1s to BASIC.(If
ADVANCE
again) .
Choose desired servo and
reverse its direction of travel.
Ex: reverse rudder servo.
to CH4:RUDD ， to REV is
highlighted. ‘Are you sure ?’ displays
for 1 sec.
Adjust travels as needed to
match model’s recommemded
throws.(usually listed as high
rates.
In BASIC menu, choose END
POINT.
to END POINT to choose end point.
Adjust the servo’s end points.
(Ex: elevator servo).
Return to BASIC menu.
to ELEV. Elevator Stick ，
until up travel is as desired. Elevator
Stick
， until down travel is as desired.
Re
p
eat as needed.
Activate THR-CUT.
Open THROTTLE-CUT
function.
to THR CUT
Activate the function. Choose
desired switch and position to
activate.
to MIX, ， to OFF
to SW ， to SwC,
to POSI ， to DOWN,
With THROTTLE STICK at
idle, adjust the rate until the
engine consistently shuts off,
but throttle linkage is not
binding.Close
SwC
to down position， Throttle
Stick
，to RATE ， until shuts off.
Set up throttle curve for
normal. (Usually changes will
not need to be made prior to
first flight.）
Open the THR-CURV/NOR
function. Adjust if needed.
Close the function.
to THR-CURVE ，COND:NORM，
to point 1> ， to 5%, .
Move to next. Re
p
eat.
Set up collective pitch curve
for normal as base of -4,
center of +5,end of +8 to +10
degrees of blade pitch for
aerobatics.2 (If just learning to
fly, ask your instructor.)
Open the PIT-CURV/NO R
function.
Adjust each point to desired
Curve.（Ex:first Point:8%）
Close the function.
to PIT-CURVE ， COND:NORM ，
to point 1> ， to 8%, , to
next point. Repeat.
Set u p revo. mixing for
normal. (For heading-hold
gyros, inhibit revo.)
Open the REVO./NOR
function.
Adjust to your desired starting
point.
to REVO.MIX ，COND:NORM， t
o
point 1> ， to 10%, , to next
point. Repeat.