User's Manual

68
hover.Land/shut engine
of f . A d j u s t t hrottle curves
and rudder trim. Repeat until
model hovers smoothly at
half throttle.Rapidly apply
throttle from 1/4 to 1/2
stick. Adjust
REVO
.
points 2 and 3
until the model does not rotate
its nose up on throttle
application.
Adjust
PIT-CURV/NOR
Repeat above as needed
Adjust
REVO.MIX
Repeat above as needed
Hig h poi nt : Ad ju s t
collective pitchcurve to +8
to +10 degrees. From hover,
throttle up rapidly. If
engine bogs,increase the
throttle curve. If engine
over-revs , i ncrease the
collectiv e pitch curve at points
6 or 7. Apply full throttle
while hovering , then descend
back to
hover. Adjust
REVO
.
until the nose does
not change
heading.
Adjust
THR-CURV/NOR
Repeat above as needed
Adjust
PIT-CURV/NOR
Repeat above as needed
Adjust
REVO.MIX
Repeat above as needed
5.3.3 GYRO SENSE
About GYRO SENSE, please refer to 3.3.12, by following steps:
Goals Steps Inputs
Set u p heading-
hold /AVCS gyro
with
heading-hold/AVC
S setting in
idle-ups 1and2
and normal mode
setting in idle- up3
and normal.
Open and activate the GYRO
SENSE function.
for 1s to BASIC.(If ADVANCE
again) .
to GYRO-SE NSE
Activate the function.
to MIX ， to ACT.
Optional: Change gyro types to
Heading- hold
(
GY
).
to MODE ， to GY
Optional: Changes switch
assignment.
Ex: select
Cond
.
to SW ， to Cond
Adjust gyro rates as needed.
(Ex:
NORM
,
IDL3
to
NOR 50%
.
IDL1
and
2
to
AVC 50%
as starting
points.)
to NORM, ， to NOR 50%
to IDL1 ， to AVC 50%
Repeat.