User's Manual

72
Adjust trim settings as needed.
(Ex:rudder to
+8%
.)
to RUDD ， to +8%，
Close menus and confirm
slowed transitions.
E (AT9) from NORMALto IDL2.Check the
changes of rudder trim.
5.3.8 DELAY:
The Delay function provides a smooth transition between the trim positions whenever OFFSET, REVO,
MIXING, or THROTTLE HOLD functions are turned on and off.
ADJUSTABILITY:
• Separate delay times are available for aileron, elevator, r udder, throttle, and pitch.
•
With a 50% delay setting, the servo takes about a half-second to move to its new position, quite a long
time.
• In general, delays of approximately 10-15% are sufficient.
Goals Steps Inputs
Set up a delay on all
channels to ease the
transition from one flight
condition to another so
there are no ‘hard
jumps’.
Open the
DELAY
function.
to BASIC menu, again to ADVANCE
to DELAY
Adju s t
AILE res ponse
as
needed. (Ex: aileron to
+8%
.)
to RATE-AILE ， to 8%,
Repeat for o ther channels.
to ELEV. Repeat steps above.
Close menus and confirm
slo we d transitions.
E(AT9) from NORMALto IDL2.Check
that the servos move gradually to new
positions
5.3.9 GOVERNORS:
The Governor mixing function is used to adjust the Governor speed settings (rS1, rS2, rS3) from the
transmitter.
What is a governor? A governor is made up of a set of sensors which read the RPM of the helicopter’s
head, and a control unit t hat automatically adjusts the throttle setting to maintain a constant head speed
regardless of changes in pitch of blades, weather conditions, etc. Governors are extremely popular in
competition helicopters due to the consistency provided.
How does it help i n helicopter setup? The governor eliminates the need to spend large amounts of time
setting up throttle curves, as it automatically adjusts the engine’s RPM to maintain the desired head speed.