User's Manual

7
shown below.
• Most AT9 functions may be reassigned to non-default positions quickly and easily. Always
check that you have the desired switch assignment for each function during set up.
Switch/Knob
AorH
Airplane (
ACRO
) Sailplane/Glider
(
GLID
)
Helicopter (
HELI
) Aircraft
SWITCH A elevator dual rate
ch10
elevator dual rate
down=butterfly on
ch10
elevator dual rate
ch10
elevator dual rate
ch10
SWITCH B rudder dual rate
ch9
rudder dual rate
ch9
rudder dual rate
ch9
rudder dual rate
ch9
SWITCH C up =
ELE-FLP
on
center/down=
IDLE-D OWN
down =
AIRBRAKE
on
up =
ELE-FLP
on
center = Distance
cond.
down = Landing cond.
governor attitude
SWITCH D aileron dual rate aileron dual rate aileron dual rate aileron dual rate
SWITCH E or
G*
Landing gear/ch5
——
Throttle hold/ch5 ——
SWITCH F or
H*
Snap roll /trainer trainer Trainer/throttle
cut
trainer
SWITCH G or
E*
——
up = Speed cond. idle-up 1 and 2
——
SWITCH H or
F*
——
down = Start cond.
idle-up 3 /gyro
——
KNOB A
Flap/ch6
(
flap trim if
FLAPERON
on)
Flap/ch6
HOVERINGPITCH
ch 6
KNOB B ch 8 ch 8
ch 8
ch 8
KNOB C Spoiler/ch7
(disabled if
AIL-DIFF
on)
ch 7
(disabled if
AIL-DIF
on)
HOVERING
THROTTLE
ch7
ch 7
SLIDER D
—— ch 5 —— ——
1.1.3 Receiver
：
R9D
AT9 system support Receiver R9D is 9 shift 2.4G FHSS spread spectrum technology.
1.2 RADIO INSTALLATION
1.2.1 Gudelines to mount the servos, receiver and battery
• Make certain the alignmen tab on the battery,switch and servo conectors is orient correctly and ‘key’ into
the corresponding notch in the receiver or connectors before plugging them i n .When unplugging connectors,
never pull on the wires. Always pull on the plastic connector instead.
• Receiver’s Anenna: In generally receiver’s antenna is longer than remote control,don’t break or retract
it,otherwise shorten the control distance.The antenna must be kept away from conductive materials,such as
metal.please make distance t est before flying.
• If your aileron servos are too far away to plug into the receiver,use an aileron extension cord to extend the
length.Avoid plugging multiple extensions together to abtain your desired length.If the distance is greater