Manual

Radiolink Electronic Ltd
www.radiolink.com
19
Note: It’s strongly advised to install the propellers AFTER all parameters setup with the
consideration of safety.
And then click “OK” and move all RC sticks and switches to their ultimate positions so the
green bars reach the limits/red lines.
Joysticks can be calibrated as following , both (Ch1 to Ch4) are pushed to the
limits(up/down/left/right)
Note: AT9S/AT10II/AT9/AT10 can be calibrated as the below example T8FB
If the green bars do not change when pilots toggle the sticks, please check if the receiver has
connected successfully. Also, check if every corresponding green bar for every channel works as
listed:
CH1: low position = roll (towards the left), up position= roll (towards the right).
CH2: low position =pitch(forward), up position =pitch(backwards).
CH3: low position =reduced speed (downward), up position =speed up(upward).