Manual

Radiolink Electronic Ltd
www.radiolink.com
25
To activate the battery detector:
• Monitor- 4 Battery and voltage
• Sensor- 0: Other
• APM version- 4: The Cube or Pixhawk
To inactivate the battery detector:
• Monitor- 0 disable
When the detector is activated, the data could possibly fail to display. Please disconnect the
flight controller from the computer and repower on the flight controller then open the above
sheet to input the measured voltage. When 2. Battery Voltage (Caled): the voltage displayed is
same as the input value and no change means setup with success. When different, please reopen
the sheet and input the measured voltage.
Note: If fail to setup, the aircraft may be impossible to arm, or buzzer may keep the Dee
sound after arming, please reset to correct. If failsafe function is always on, the battery low voltage
protection maybe activated and the detected voltage is INACCURATE. Please measure the voltage
and input the correct value.
Throttle Failsafe
Transmitter Setup
Pull the throttle trim lever to -120 => Long press MODE to BASIC MENU => Turn the dial to
select F/S(FAILSAFE) and push to enter=> Turn the dial to select CH3:THRO => Pull the throttle
stick to the bottom => Long press PUSH to get the throttle percentage 3% => Press END to the
main display => Push the throttle trim lever back to 0. The Failsafe setup is complete.
[ F/S ]
CH3: THRO
AILE
ELEV
THRO
RUDD
ATTI
AUX1
AUX2
AUX3