Manual

Radiolink Electronic Ltd
www.radiolink.com
27
(6) Hold the throttle to Minimum and disconnect the battery to exit ESC calibration mode.
When all the above parameters set, propellers can be installed and arm the aircraft. For the
arming steps, please refer to 2.1.2 RTF version Armed
WOLF QAV210 racing drone is equipped with Radiolink MINI M8N GPS TS100 as factory
default. If the Pos-Hold Mode and RTL Mode are needed, please go to outdoor open space and
these two modes can be achieved when the satellites searched by GPS.
Green indicator on GPS TS100 flashes means satellites have been captured. It needs to wait a
bit longer (about 1.5-2 minutes, and longer in cloudy day) after powering on QAV210 for the first
flight to make sure the satellite captured reaches 18 or above. In this case, the accuracy of
Pos-Hold and RTL will be better.
2.2.5 Propellers Installation
WOLF QAV210 stand-alone version is NO propellers installed for the package reason. So
when the above steps are done setting(parameters set, ESC calibrated, arm successfully after
powering on), propellers are ready to be installed. Make sure the correct installation of each
positive/counter propeller. otherwise the aircraft may fail to take off.
As the image shown below, put the head with camera forward when installing props and
make sure propellers on Motor 1 and 2 rotate counter clockwise while that on Motor 3 and 4 are
clockwise.
Rotate
clockwise
Rotate
clockwise
Rotate
counter
clockwise
Rotate
counter
clockwise