Instructions for Use

Goals

Steps

Inputs

Revers the direction

of the elevator

servo.

Open REVERSE function

for 1s .(If ADVANCE again)

to REVERSE, PUSH.

Choose proper channel and

set direction(Ex:ELEV REV)]

to ELEV，

to REV，’Are you sure? displays

for 1s。

2.3.7 Dual/triple rates and exponential (D/R,EXP)

Dual/Triple Rates: reduce/increase the servo travel by flipping a switch, or (ACRO GLID) they can be

engaged by any stick position. Dual rates affect the control listed, such as aileron, not just a single (ex:

channel 1) servo. For example, adjusting aileron dual rate will affect both aileron servos when using

FLAPERON or AIL-DIF, and both aileron and elevator servos’ travel when using AILEVATOR or ELEVON

or a CCPM helicopter.

Activation:

• Any SWITCH, A-H. If you choose a 3-position switch, then that dual rate instantly becomes a triple rate.

• The glider programming offers you the choice of Condition. This option allows you to have a separate rate

for each of condition. (GLID)

• Stick position (ACRO GLID). (Ex: On rudder you normally use only the center 3/4 of the stick

movement except for extreme maneuvers such as snaps/spins/stalls. As long as your RUDDER STICK does

not exceed 90% (ie. stall turn), the rudder goes to high rate's 90%, which is a MUCH higher amount of travel

than your low rate at 89%)

Adjustability: