Radiolink Electronic Ltd www.radiolink.com BYME-D Flight Controller Of Delta Wing Instruction Manual Radiolink Electronic Ltd www.radiolink.
Radiolink Electronic Ltd www.radiolink.com Thanks for purchasing Radiolink flight controller Byme-D . To fully enjoy the benefits of this product and ensure safety, please read the introduction carefully and set up the device as described below: If any problems found during the operation process, please kindly refer to the manual first. Then pilots could contact our distributors to find solution or follow our Facebook homepage https://www.facebook.
Radiolink Electronic Ltd www.radiolink.com 1. Introduction Byme-D is applicable to all model airplanes with mix elevator/aileron controls including delta wing, paper plane, SU27,F22 and is SBUS and PPM signal supported There are three flight modes: Stabilize Mode, Gyro Mode and Manual Mode. Button: Servo phase adjustment Aircraft Head Indicator: Status/ Servo Phase CH1：Left Servo Receiver：SBUS/PPM CH2：Right Servo NULL CH3: Throttle Radiolink Electronic Ltd www.radiolink.
Radiolink Electronic Ltd www.radiolink.com 2. Parameters Input Voltage：DC 5V （Max. 6V） Pin：2.54mm * 3 pin * 5 Weight: 2.5g (with pins) Dimension: 35*14.65mm 3. Installation Make sure the arrow on Byme-D points to the aircraft head. The flight controller can be installed either face up or down with 3M glue on the aircraft body and the wires connect to the corresponding pins. 4. Flight Modes Setup Flight modes can be set by CH5 (3-way switch) on transmitter.
Radiolink Electronic Ltd www.radiolink.com 6. Transmitter Phase Setup CH3 - Throttle: Reversed Other channels: Normal 7. Power-On Calibration When the aircraft is powered on, the gyro on Byme-D will calibrate with the green led flashing. Please keep the aircraft remain still until the green light is always on. 8. Attitude Calibration The flight controller needs to calibrate the attitudes/level to ensure the balanced status.
Radiolink Electronic Ltd www.radiolink.com 9. Servo Phase Make sure the servo phases are correct before flight. Take Manual Mode and Mode 2 as example. Rolling to left Left aileron lifted Left aileron lifted Right aileron pressed Right aileron pressed Left aileron lifted Right aileron lifted Pitching downward 10. Output Servo Phase Adjustment Press the button at the front of Byme-D to change the servo phase: Short press once, aileron mix control reversed, LED1 ON/OFF.
Radiolink Electronic Ltd www.radiolink.com Model leans to left Model leans to right Model head lifts ( move backward) Model head pressed Rolling to left Rolling to right Pitching downward Pitching upward (move forward) Joystick centered Model levels Gyro Mode The model rotation is controlled by joysticks with gyro increasing the stability. This is an advanced mode. The model won’t level but and keeps 2 Radiolink Electronic Ltd www.radiolink.
Radiolink Electronic Ltd www.radiolink.com rotating when joystick is loose . Models rotates horizontally Rolling to left Models rotates vertically Pitching downward 3 Manual Mode Pilots control servos with corresponding channels by transmitter, neither attitude nor gyro involved. 12. Gyro Sensitivity There is certain stability margin for the Byme-D PID control. To different models, if Byme-D under correct or over correct, pilots can try adjusting the rudder angle.
