TX16S Instruction Manual

41
Curve: Curve settings
Diff
Adjust the stroke amount on one side with the midpoint as the boundary
Expo
Expo curve setting. Increasing a positive value will make the gimbal smoother and
smoother when approaching the midpoint, while increasing a negative value will
make the gimbal more acute when approaching the midpoint.
Func
Preset
function
X>0
Positions above 0 (midpoint) follow the gimbal output, operations
below the midpoint are all fixed to the midpoint value of 0
X<0
The opposite of the previous one
|X|
Absolute values, negative values less than the midpoint will always
become positive values, and the actual performance is a V-shaped
curve
f>0
Below the midpoint 0 is fixed at midpoint 0, above the midpoint is fixed
at 100, the actual performance is that the gimbal becomes 0 and 100 to
switch, there is no intermediate process
f<0
The opposite of the previous one
|f|
Above the midpoint is fixed at + 100%, and below the midpoint is fixed
at -100%. The actual performance is that the gimbal becomes -100%
and + 100% to switch. There is no intermediate process.
Cstm
Call custom curve (CV1-CV32), custom curve is set in curve page CURVE
Modes: Select the corresponding flight mode, and the output trimming value that
affects this entry can be set by the flight mode entry
Switch: Select the switch to activate this item (Note: This setting is added to this
item to add multiple lines of different settings to switch, if there is only one line
setting, do not set the activation switch, otherwise the switch will cause this item
to be completely invalid)
Side: Unilateral setting with the midpoint as the boundary. No matter how this
item is set, it will be set to unilateral effect by Side.
x>0
All below the midpoint are fixed at 0, and normal output above the midpoint
x<0
All above the midpoint is fixed at 0, and normal output below the midpoint
Trim: You can choose whether the fine-tuning is effective for this entry, or you can
define a fine-tuning that affects this article separately.