TBS Crossfire Manual



● SNR - Signal-to-noise ratio, compares the level of a desired signal to the level of background noise
Oled Menu
When you scroll to the left/ right, you can see the other diagnostic screens, showing you informations of
you link etc:

Find Mode
The Find-mode provides you with a way to locate a downed aircraft. A GPS signal is currently required to
use this mode. Install our TBS GPS module by BST or any other GPS, connected to a flight controller.
In normal use the GPS coordinates are continuously updated and the latest data is displayed on the “Find
Mode” screen. If the model loses power you can review the last known coordinates to locate your model.

● Inactive (Press Enter) / Active - Enable/disable the Find-mode, shows on-board LiPo voltage
Do NOT enable during flight!
● Signal - Receiver signal strength, makes it possible to triangulate the location [0 to 100%]
● Alt - Altitude above Sea Level, GPS required
● Lat - Latitude, GPS required
● Lat - Longitude, GPS required
The standard div. receiver has an on-board LiPo battery to
operate in beacon-mode, on the nano div. receiver you got



33