TBS Crossfire Manual



Link regained
Once you got your link back to your copter/plane you can now try to find it. It’s recommended to keep the
mode you got your signal back no matter if it’s actually find mode or selected operation mode.
● GPS source attached to receiver
○ The receiver will share the latest coordinates with the transmitter and display them on the
OLED.
○ For Droidplanner app select Bluetooth ( Crossfire App link mode needs to be set to
MAVLink emulator ) to locate your copter/plane
○ Write down the coordinates use any GPS to find the location
● No GPS source attached
○ Make your transmitter antenna a directional one. This can be done by the DIY reflector or
you can use your body to lower the signal strength from one direction ( works for
emergencies )
○ Turn yourself slowly in a circle and try to figure out the direction the signal strength is the
strongest. Walk this direction and repeat this until you find the copter/plane. For this
practice some exercise is recommended.

Disable find mode on the receiver
If the receiver is in Find-mode it can be cancelled by pressing the “Bind”-button 3x. So if you are back
home and the receiver still thinks it got lost, you can turn it off by this. Or check the OLED screen to
deactivate the Find-mode from the transmitter (Standard/ Lite TX).

The (on-board) LiPo battery in the diversity receiver is automatically charged every time the receiver is
used. On the Standard diversity Rx you got a third LED indicator on the front face displays the current state
of the battery.

 


LiPo LED indicator
Status
Red ▀ ▀ ▀
Backup battery is charging

37