TBS Crossfire Manual

LQ warning in OpenTX
The setup for the radio is relay simple:
What they mean:
L01: Monitors the Crossfire frequency mode, activated when it's not in 150Hz mode
L02: Activ when the Link quality drops below 80% (pre warning) AND 50 or 4 Hz mode is active
L03: Same as L02 but with the critical warning level at 70%
L02 and L03 also got a small delay (0.5s) to avoid warnings when the signal is only bad for a short moment.
Note: since Crossfire fw 2.93, the RFMD no longer needs to be compared as the LQ sensor will stay
at 100% while in 150Hz mode (RFMD = 2)
When you use the 150Hz locked mode of the Crossfire, the levels are 40% for L02 and 30% for L03
With the logical switches the voice alerts will be triggered every time they are active. What they mean:
SF1: when L02 is activ, plays the selected track ones -but not at the startup
51