TBS Crossfire Manual



Wireless configuration with ArduPilot/ PX4 by WiFi

Over the built-in WiFi module you can get MAVLink data to your pc or mobile device for live telemetry as

well as full MAVLink data transmission (as with the bluetooth module).

You need to set up your wifi module for that to work before.

You can connect to your Crossfire in two ways:

● Both are in the same WiFi network

● Straight connection to the Crossfire access point

When you are connected, you need to use the following settings:

● Connection type: UDP

● Port: 8888

The port can be changed in the settings of the WiFI module, if you need to.

With WiFi FW 1.17 you can enable or disable the MAVLink data. To change this, navigate to and set

MAVLink 

to 

on

.



Make sure your Crossfire is in RF mode 

dynamic 

or 

forced 150Hz.

Note: in 1.17 there is a bug which turns the Mavlink option off everytime time you shut your transmitter

down

Wiring diagram



61