TBS Crossfire Manual



Signal strength in Betaflight - BF < 4.1 and DJI OSD
If you use an older BetaFlight version or a new one but with a DJI HD system, you need to assign the LQ
sensor to a channel.
Keep in mind, that the LQ will remain at 100% while the Crossfire is in 150Hz mode!

In the Crossfire receiver channel mapping, assign LQ to an unused channel. If you set it up by LUA, you can
assign it to channel 1, even when you use the 8 channel mode of the crossfire.
In BetaFlight, set the assigned channel as RSSI Channel  (AUX1 = channel 5, etc)

 



65